Wilson Electronics LLC 2B4310SM Benutzerhandbuch

2B4310

Connectors

FME-Male

impedance (input/output)

50 Ohms

Dimensions

5 x 3.5 x 1.2 inch or 12.7 x 8.9 x 3 cm

Weight

1.03 lbs or 0.468 kg

Frequency

896-940 MHz / 1850-1990 MHz

25 dB typical, 30 dB maximum

900 MHz

8 MHz maximum

1900 MHz

74 MHz maximum

900 MHz

1900 MHz

CDMa

29.0 dBm

gSM

29.2 dBm

EDgE

29.0 dBm

iDEn

29.6 dBm

900 MHz

1900 MHz

CDMa

8 dBm

gSM

8 dBm

EDgE

8 dBm

iDEn

-6.6 dBm

received channels (downlink).  

The maximum power is reduced by 

the number of channels:

number of 

channels

Maximum Power

900 MHz

1900 MHz

2

5.8 dBm

13.3 dBm

3

2.2 dBm

9.8 dBm

4

-0.3 dBm

7.3 dBm

5

-2.2 dBm

5.3 dBm

6

-3.8 dBm

3.8 dBm

noise Figure (typical)

3.5 dB nominal

isolation

uplink/downlink more than 50 dB

12 V, 2 a (subject to uplink power)

notes:

1. nominal gain is the maximum gain at any frequency in the passband.

2. Nominal bandwidth is the difference between two frequencies that are adjacent to the passband where the amplification is 20 dB 

lower than the passband amplification.  One of the frequencies is lower than the passband and the other is higher.

3. The Manufacturer’s rated output power of this equipment is for single carrier operation.  For situations when multiple carrier 

signals are present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can 

cause interference to adjacent band users.  This power reduction is to be by means of input power or gain reduction and not by 

an attenuator at the output of the device.

4. The maximum power for 2 or more simultaneous signals will be reduced by 6 dB every time the number of signals is doubled.

3301 East Deseret Drive, St. George UT 84790

For additional Technical Support visit

www.wilsonelectronics.com

Phone: 866-294-1660        Fax: 435-656-2432

Part #110481 AIG SBi 007 / 02.11.08