Wilson Electronics LLC 460002 Benutzerhandbuch

Warning: In a wireless installation, do not 

plug the Signal Booster directly into the cell 

phone and/or data card using an antenna 

adapter . It may damage the Signal Booster, 

cell phone and/or data card

 .

Installing the Outside Antenna
To receive the best cell signal, select a location in the 

center of the vehicle’s roof 12 inches away from any other 

antennas or windows . If the vehicle has a sunroof, it is 

important to separate the Inside and Outside Antennas by 

at least five feet . This prevents the Signal Booster from 

overloading or oscillating . As shown above . Follow the 

specific antenna installation instructions included with the 

Outside Antenna .
Separation of the Inside and Outside Antennas is very 

important . The metal roof of the vehicle acts as a barrier 

and helps shield the two antennas from each other, 

preventing oscillation (feedback) .
The Outside Antenna must be installed vertically .  Signal 

performance will be degraded if the antenna is not vertical .
The antenna cable may run through the door to the Signal 

Booster .
For a more professional looking installation, run the 

antenna cable under the door seal . The antenna cable is 

small enough to easily tuck under the door seal or plastic 

molding . Carefully pull down the door seal .  Run the cable 

through the seal and push the seal back into place .  This 

prevents constant wear and tear on the cable as the door 

opens and closes .

Warning: Do not plug in the DC power 

supply until the Outside and Inside 

Antenna cables are attached to the Signal 

Booster .

HUMME

R

HUMME

R

Outside

Antenna

Inside

Antenna

Distance between antennas 

through a sunroof must be 5 

feet or more .

DC Power 

Supply

Signal 

Booster

Cell Phone

PDA

Notebook

Before Getting Started
This guide will help you properly install your Wilson Electronics Dual-Band Mobile Wireless Signal 

Booster .

prior to installing any equipment. Read through the instructions, visualize where all the equipment 

will need to be installed and do a soft installation before mounting any equipment . Contact Wilson 

Electronics Technical Support Team with any questions at 866-294-1660 .