Wilson Electronics LLC 460011 Benutzerhandbuch

 

• At least 8 inches from any people. 

 

 The Outside Antenna must be 

installed vertically on a metallic 

surface .

 
2 .   Run the Outside Antenna cable into 

the car . The cable is strong enough 

that it may be shut in most vehicle 

doors without damaging the cable . 

For a cleaner look, carefully pull down 

the door seal, run the cable under 

the seal, and push the seal back into 

place . This method reduces wear 

on the cable as the door opens and 

closes .

 
3.  Install the Low-Profile Inside Antenna.
 

•  Identify a place on the right side of 

the driver’s seat to mount the Inside 

Antenna . The location should be at 

least 18 inches but no more than 

36 inches from where the cellular 

device will be used .

 

 •  Install the Inside Antenna at the 

same angle as the cell phone when 

held in use or near the laptop’s 

cellular data card to maximize signal 

strength .

 

  For a more professional look, you 

can install the Inside Antenna 

underneath a car seat cover or 

upholstery .

 

•  When you have tested the 

functionality of your Signal Booster, 

mount the Inside Antenna by peeling 

off the backing of the Velcro

®

 and 

attach it to your selected location 

on the seat and secure the Inside 

Antenna .

4 .   Place and connect the MobileMaxx 

3G Signal Booster .

 

•  Select a location for the Signal 

Booster that is free from excessive 

heat, direct sunlight and moisture 

and that has proper ventilation . 

Good locations include underneath 

a seat or under the dashboard .

 

•  Connect the wire from the Outside 

Antenna to the port labeled “Outside 

Antenna” on the Signal Booster .

 

 

•  Connect the wire from the Inside 

Antenna to the port labeled “Inside 

Antenna” on the Signal Booster .

 

•  Plug the power adapter into 

vehicle’s 12V DC power supply 

and attach the cord to the side of 

Power Booster labeled “Power .” 

NOTE: Do NOT connect the power 

to the Signal Booster until you have 

connected both the Inside and 

Outside Antennas .

 

•  Power up your Signal Booster by 

flipping the switch on the back of 

the DC power adapter on . A red 

light should appear on the power 

adapter .

Note: The MobileMaxx 3G Signal Booster 

may remain on, in vehicles whose 12V 

DC power sources do not automatically 

shutdown when the vehicle is turned 

off . This could result in discharging the 

vehicles battery in one to two days . 
Note: Some 12V DC power sources are 

shut down when the vehicle ignition is 

turned to off . Refer to your vehicle owners 

manual for specifics related to your 

vehicle . 
Note: The aluminum casing of your Signal 

Booster will adjust to the temperature of its 

environment, but is designed to protect the 

Signal Booster technology . For example, 

in the summer, the Signal Booster case