Wilson Electronics LLC 460013 Benutzerhandbuch

3 .   Attach the Adhesive Mounting Bracket to the 

vehicle’s dashboard . 

 

•   Clean the area where the bracket is to be 

mounted with the alcohol wipe included . 

Allow the area to dry . 

 

•   Peel the backing to expose the adhesive 

and press the bracket onto the desired 

location on the dashboard . NOTE: Be 

sure the tab is positioned vertically . 

   
 

•   Allow the adhesive to cure for 24 hours 

before you attach the MobilePro (Step 4) .

4 .   Attach the MobilePro signal booster to 

the Mounting Bracket . After waiting 24 

hours for the adhesive on the bracket 

to cure, attach the signal booster by 

aligning the rectangular hole on the back 

of the signal booster with the tab on the 

Mounting Bracket, grasping the sides of 

the signal booster, and sliding it downward 

approximately ¼ inch into place.  

The Mounting Bracket is designed to swivel 

for more convenient viewing angles . Once 

the signal booster is in place, you can adjust 

the angle of the bracket by loosening the 

knurled nut, applying gentle pressure to the 

top or bottom of the signal booster, and then 

tightening the nut when the desired angle is 

achieved .

5 .   Attach the antenna cable to the antenna 

connector on the bottom of the signal booster .  

The antenna cable must be connected before 

going to the next step.

6 .   Power up your MobilePro . Connect the 

power cable to the mini-USB port on the 

bottom of the signal booster . Connect the 

other end of the power cord to the DC 

adapter and insert the adapter into the 

vehicle 12V DC power source . Use only the 

supplied Wilson Electronics power supply . 

While the MobilePro may remain on, leaving 

the MobilePro on in a vehicle when it is not 

running may discharge the battery in a day 

or two . Also note that some 12V DC power 

sources are shut down when the vehicle 

ignition is turned to off . 

Alternative Mounting for Weak Signal Areas.
If you know you drive through particularly weak 

signal areas, you may want to mount your signal 

booster closer to your cell phone when in use . 

To do this, attach a strip of double-sided Velcro 

(available at most hardware or fabric stores) to 

the back of the MobilePro and to your center 

console of your vehicle . Press MobilePro to 

console .