Wilson Electronics LLC 460013 Benutzerhandbuch
4
Need help?
www.WilsonElectronics.com
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
3 . Attach the Adhesive Mounting Bracket to the
vehicle’s dashboard .
• Clean the area where the bracket is to be
mounted with the alcohol wipe included .
Allow the area to dry .
• Peel the backing to expose the adhesive
and press the bracket onto the desired
location on the dashboard . NOTE: Be
sure the tab is positioned vertically .
• Allow the adhesive to cure for 24 hours
before you attach the MobilePro (Step 4) .
4 . Attach the MobilePro signal booster to
the Mounting Bracket . After waiting 24
hours for the adhesive on the bracket
to cure, attach the signal booster by
aligning the rectangular hole on the back
of the signal booster with the tab on the
Mounting Bracket, grasping the sides of
the signal booster, and sliding it downward
approximately ¼ inch into place.
The Mounting Bracket is designed to swivel
for more convenient viewing angles . Once
the signal booster is in place, you can adjust
the angle of the bracket by loosening the
knurled nut, applying gentle pressure to the
top or bottom of the signal booster, and then
tightening the nut when the desired angle is
achieved .
5 . Attach the antenna cable to the antenna
connector on the bottom of the signal booster .
The antenna cable must be connected before
going to the next step.
6 . Power up your MobilePro . Connect the
power cable to the mini-USB port on the
bottom of the signal booster . Connect the
other end of the power cord to the DC
adapter and insert the adapter into the
vehicle 12V DC power source . Use only the
supplied Wilson Electronics power supply .
While the MobilePro may remain on, leaving
the MobilePro on in a vehicle when it is not
running may discharge the battery in a day
or two . Also note that some 12V DC power
sources are shut down when the vehicle
ignition is turned to off .
Alternative Mounting for Weak Signal Areas.
If you know you drive through particularly weak
If you know you drive through particularly weak
signal areas, you may want to mount your signal
booster closer to your cell phone when in use .
To do this, attach a strip of double-sided Velcro
(available at most hardware or fabric stores) to
the back of the MobilePro and to your center
console of your vehicle . Press MobilePro to
console .
Alternative mounting options
available. Contact Tech
Support at 866-294-1660
for details.