Wilson Electronics LLC 460031 Benutzerhandbuch

2

Signal Booster

2’ Wilson 400

Lightning Surge

Protector

To purchase Expansion Kits call Wilson Electronics Sales Department at: 888-503-5329

1.  Select a location on the roof or outside of the building to install the outside 

antenna. Refer to pages 3 & 5.  

2.  Select a location to install the Signal Booster that is away from excessive heat, 

direct sunlight or moisture, and has adequate ventilation. Airtight enclosures 
are not recommended. Booster should be as close to the outside antenna as 
possible in order to minimize losses from cable length to outside antenna. 

3.  Connect the cable from the outside antenna to the signal booster’s “outside 

antenna” connector. Refer to page 6 for more information on running cable. 
Lightning Surge Protection is recommended for all in-building installations. 
Refer to pages 3 & 6.

4.  Select a location for the inside antennas. Try to choose a position in the center 

of the area needing improved signal. Keep in mind that proper inside antennas 
to outside antenna isolation is necessary for the system to function properly. 
This may require as much as 50 to 75 feet of horizontal separation from the 
outside antenna. Vertical separation also helps increase isolation. Alternate 
means of isolation are possible. If physical separation is not possible, please 
contact Wilson Electronics Tech Support at 866-839-9361 for suggestions on 
alternate methods to achieve isolation. 

5.  Connect the cable from the inside antennas to the signal booster’s “inside 

antenna” connector. Refer to page 6 for more information on running cable. 
Keep cable runs as short as possible to reduce signal loss in the system.

Refer to Installation Diagram on page 3 & 4. Contact Wilson Electronics Technical 
Support Team with any questions at 866-839-9361

.

Wide Band Directional

Antenna 75’ Wilson 400

Wide Band Panel Antenna 

50’ Wilson 400