Wilson Electronics LLC 8013SB Benutzerhandbuch
1. PURPOSE OF THE AMPLIFIER
The PCS Smart Technology
TM
Amplifier improves RF coverage for areas in which low signal
strength is a concern.
2. PACKAGE CONTENTS
2.1 Amplifier
2.1 Amplifier
2.2 AC/DC 110 volt Power Supply
3. HOW THE AMPLIFIER FUNCTIONS
The signal is received by the outside antenna from the cell site. The signal is then
AMPLIFIED and transmitted to your phone through the inside antenna. When the phone
transmits, the signal is received by the inside antenna and then AMPLIFIED and transmitted
to the cell site through the outside antenna.
4. AMPLIFIER INSTALLATION (see illustration on pg. 4 & 5)
4.1 Installing the Wilson Cellular Outside Antenna
WARNING:
The outside antenna used with this amplifier must be fixed-mounted on
an outdoor permanent structure with a separation of at least 20 feet from all persons
during normal operation.
4.1.1 Select a location on the roof using your phone in test mode to find the best signal
strength. (See leaflet titled PHONE TEST MODES)
4.1.2 The outside antenna should be located in an area with at least a 3 foot radius clear of
obstructions and other radiating elements.
4.2 Installing The Amplifier
WARNING:
Connecting amplifier directly to cell phone may damage phone.
WARNING:
Connect both antennas before connecting power to the amplifier.
4.2.1 Mount the AMPLIFIER on a wall or ceiling using #6 screws.
NOTE: Mount the AMPLIFIER away from direct sunlight, excessive heat and/or
moisture. The amplifier needs proper ventilation. DO NOT place the amplifier
in an air-tight enclosure.
4.2.2 Connect outside antenna to the amplifier side labeled “OUTSIDE ANTENNA”.
4.2.3 Connect inside antenna to the amplifier side labeled “INSIDE ANTENNA”.
4.2.4 Verify that both the outside and inside antennas are connected before connecting
the AC-DC power supply to the power outlet.