Xsilogy Inc. 0225HP Benutzerhandbuch
Introduction
1-2
Preliminary Release 1.0
Regulatory Compliance Information
USA
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
party responsible for compliance could void the user's
authority to operate the equipment.
This device uses, generates, and radiates radio frequency
energy. The radio frequency energy produced by this device
is well below the maximum exposure allowed by the Federal
Communications Commission(FCC).
energy. The radio frequency energy produced by this device
is well below the maximum exposure allowed by the Federal
Communications Commission(FCC).
WARNING A minimum separation distance of 20 cm.(8
inches) must be maintained between the radiating element
of the transmitter and nearby persons in order to ensure
compliance with FCC rules for rf exposure. This transmitter
must not be co-located with other transmitters or antenna
inches) must be maintained between the radiating element
of the transmitter and nearby persons in order to ensure
compliance with FCC rules for rf exposure. This transmitter
must not be co-located with other transmitters or antenna
This device complies with the limits for intentional radiator
devices pursuant to Part 15 subpart C of the FCC Rules and
Regulations. Operation is subject to the following two
conditions:
devices pursuant to Part 15 subpart C of the FCC Rules and
Regulations. Operation is subject to the following two
conditions:
1. This device must not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
operation.
The FCC limits are designed to provide reasonable
protection against harmful interference when the equipment
is installed and used in accordance with the instruction
protection against harmful interference when the equipment
is installed and used in accordance with the instruction
WARNING – Graviton components should only be installed
by qualified personnel and should not be used in a manner
inconsistent with prescribed practices. Whenever electrical
voltages are involved, the risk of physical injury or
equipment damage exists.
by qualified personnel and should not be used in a manner
inconsistent with prescribed practices. Whenever electrical
voltages are involved, the risk of physical injury or
equipment damage exists.