Netgear 08200090 Benutzerhandbuch

Safeguarding Your Network

2-15

To connect a combination of non-WPS enabled and WPS-Enabled clients to the modem router:

1. Restore the modem router to its factory default settings (press both the Wireless and WPS 

buttons on the side of the modem router for 5 seconds).

When the factory settings are restored, all existing wireless clients are disassociated and 
disconnected from the modem router.

2. Configure the network names (SSIDs), select the WPA/PSK + WPA2/PSK radio button on the 

Wireless Settings screen (see 

). 

and click Apply. On the WPA/PSK + WPA2/PSK screen, select a passphrase and click Apply. 
Record this information to add additional clients.

3. For the non-WPS devices that you want to connect, open the networking utility and follow the 

utility’s instructions to enter the security settings that you selected in Step 2 (the SSID, WPA/
PSK + WPA2/PSK security method, and passphrase).

4. For the WPS devices that you want to connect, follow the procedure 

The settings that you configured in Step 2 are broadcast to the WPS devices so that they can 
connect to the modem router. 

5. To view a list of all devices connected to your modem router (including wireless and Ethernet-

connected), see 

Note: To make sure that your new wireless settings remain in effect, verify that the 

Keep Existing Wireless Settings checkbox is selected in the WPS Settings 
screen.