Netgear 08400101 Benutzerhandbuch

Before proceeding with the wireless router installation, familiarize yourself with 
the contents of the product package. 
Follow these instructions to set up your router.

You need the DSL Internet login name and password in order to complete the 
setup.

For best wireless performance, insert the 
feet so that the NETGEAR logo on the LED 
front panel is at the top, and the power 
connector on the back is at the bottom. 

a. Turn off your computer and 

the DSL broadband 
modem.

b. Locate the Ethernet cable 

(cable 1 in the diagram) 
that connects your modem 
and PC.

c. Disconnect the cable at the computer end only, point A in the diagram.
d. Securely insert the Ethernet cable 

from your modem (cable 1 in the 
diagram) into the Internet port of the 
wireless router as shown in point B 
of the diagram.

e. Locate the cable that came 

with your wireless router. 
Securely insert it until it 
clicks into the Ethernet port 
of your computer (point C 
in the diagram), and insert 
the other end into a LAN 
port on the router such as 
LAN port 2 (point D in the 
diagram).

Warning: Failure to restart your network in the correct sequence could 
prevent you from connecting to the Internet.
a. First, turn on the broadband modem and wait 2 minutes.
b. Now, plug in the power cord to your wireless router and wait 1 minute. 
c. Last, turn on your computer. 

Note: If your Internet company installed software to log you in to the 
Internet, do not run that software. You may need to go to the Internet Explorer 
Tools menu, Internet Options, Connections tab page where you can select 
“Never dial a connection” so that this software is not automatically run 
whenever you start your browser.

d. Check the wireless router status lights to verify the following:

•

Power/Test: The power/test light blinks while the 
router is starting up, then should turn solid green 
after the router completes its startup. If it does 
not turn solid green, see the Troubleshooting 
Tips in this guide. Also, this light blinks while 
the router is being reset to its factory default 
settings, or when you update its firmware.

•

Wireless: The Wireless light should be lit. If the 
Wireless light is not lit, see the Troubleshooting 
Tips in this guide.

•

Internet: The Internet port light should be lit. If 
not, make sure the Ethernet cable is securely 
attached to the wireless router Internet port and 
the modem, and the modem is powered on.

•

LAN: A LAN light should be lit. Green indicates your computer is 
communicating with the router. If a LAN light is not lit, check that the 
Ethernet cable from the computer to the router is securely attached at both 
ends, and that the computer is turned on.

a. Type http://www.routerlogin.net in your browser address bar.
b. When prompted, enter admin for the user name and password for the 

password, both in lower case letters, and click OK.

c. If you do not see this menu, click 

Setup Wizard on the upper left of the 
main menu. 

d. Click Next and input your ISP 

settings.

e. At the end of the Setup Wizard, click 

Apply to save your settings.

f. Click Test to verify your Internet connection and register your product. 

These settings enable basic wireless connectivity that let you set up your 
wireless computers and test wireless Internet access through the router.