Netgear 14200281 Benutzerhandbuch

Installation

WND930

Before mounting the access point in a high location, first set up and test the 
unit to verify wireless network connectivity.

Note: 

The access point has a DHCP client enabled by default. If a DHCP server 

exists in your network, the access point obtains an IP address from the DHCP 
server. If a DHCP server is not detected in your network after 30 seconds, the 
access point sets its IP address to a static IP address of 192.168.0.100.

¾

1.  Using an Ethernet cable, connect a power sourcing equipment (PSE) to 

a PoE port on the access point.

Note: 

You must supply either AT power to at least one LAN port or AF power 

to two LAN ports to power the access point. You must supply AT power to 
both LAN ports to receive PoE power out.

2.  If a DHCP server is not connected to your network, configure a 

computer with a static IP address of 192.168.0.210 and a subnet mask 

of 255.255.255.0.

3.  Connect an Ethernet cable from a LAN port on the access point to a 

LAN port on the PC.

4.  Check the LEDs to verify that the access point is set up correctly.

Unpack the box and verify the contents:

•  Outdoor High Power Wireless N Access Point
•  Wall mounting bracket
•  Four bracket screws
•  Two pole mount clamps
•  Three weatherproof cable glands 

Power LED

•Off. Power is off.
•Solid green. Power is on.
•Amber, then blinking green. A self-test is running or software is being 

loaded. During startup, the LED is first steady amber, then goes off, and 

then blinks green before turning steady green after about 45 seconds. If 

after one minute the LED remains amber or continues to blink green, it 

indicates a system fault.

Activity LED

•Off. There is no network traffic through the access point.
•Blinking green. There is network traffic through the access point.

2.4G WLAN 
LED

•Off. The wireless interface is off.
•Solid green. The wireless interface is on.
•Blinking green. Wireless activity is detected on the 2.4G band.

5G WLAN LED

•Off. The wireless interface is off.
•Solid green. The wireless interface is on.
•Blinking green. Wireless activity is detected on the 5G band.

Heater LED

•Off. Heater is off.
•Solid green. Heater is on.

LAN port LEDs

•Off. No link is detected.
•Solid green. Link is detected.
•Solid amber. 10/100/1000 speed connection is detected.
•Blinking amber. 10/100/1000 speed activity is detected.

¾

1.  Connect to the access point by opening your browser and entering the 

access point’s IP address
If a DHCP server is not installed in your network, the default IP address is 

192.168.0.100.
A login window displays.

2.  Enter 

admin for the user name and password for the password, both in 

lower case letters.
The access point user interface displays.

3.  Select 

Configuration > System > Basic > General from the menu.

Operation 

temperature : 

-20℃ to +60℃ 

Operation voltage: Input: 44-57Vdc, 0.45A (per each PoE In) 

Output: 51Vdc, 15.4W