Netgear 17200386 Benutzerhandbuch

Quick Start

Model VNB4000-111PAS

The Wire-Free IP Camera Base Station accepts WiFi streaming video data from 
NETGEAR Wire-Free IP Cameras and delivers the video data to ONVIF-compliant 
VMS platforms such as Milestone. The base station is compatible with NETGEAR 
Wire-Free IP Cameras model VNC4030-111PAS. Each base station supports WiFi 
streaming from up to four IP cameras.

You can mount the base station on a ceiling or wall, or install it on a flat surface. 
For optimal antenna performance, we recommend mounting the base station on a 
ceiling or installing it on a flat surface. For information about how to mount the base 
station on the ceiling, see 

 on the other side of this 

document.

1.  Use an Ethernet cable to connect the base station to a router or switch.
2.  Connect the power cord that 

came in the package to the 

base station and plug it in to an 

electrical outlet.

3.  Press the 

Power button on the 

rear of the base station.
The Power LED and the Network 
LED light solid green.

1.  Make sure that the rechargeable battery is installed in the camera and 

the camera is powered on.
For information about how to install the camera battery, see the Wire-Free IP 
Camera Quick Start Guide that came with the camera.

2.  Place the camera 2-to-4 feet (60–120 cm) from the base station.
3.  On the base station, press the 

SYNC button.

The Sync LED on the base station begins blinking 
blue. This indicates that the base station is 
attempting to pair with a camera.

4.  On the camera, press the 

SYNC button.

The camera LED blinks blue. This indicates that the camera is attempting to pair 
with the base station.

When the camera is paired to the base station, the base station Sync LED blinks 
blue rapidly and then lights solid green.

5.  Repeat Steps 1–4 to pair more cameras to the base station, if desired.
6.  Move the cameras to the desired locations.

During initial setup, your computer or mobile device must be connected to the same 
LAN as the base station. An Internet connection is not required. 
1.  Connect your computer or mobile device to the same LAN as the base 

station. 
If you are unable to connect to the same LAN using WiFi, use an Ethernet cable 
to connect a computer to the same router or switch as the base station.

2.  Launch a web browser.
3.  In the address field of the browser, enter <??>

A login window displays.

4.  Enter 

admin for the user name and enter the password.

The default password is 

password.

5.  When prompted, create a new password.

You are prompted to select 60 hz or 50 hz for the flicker setting.

6.  Either accept the 

60 hz default setting, or select 50 hz.

The home page displays all cameras that are paired to the base station.

To change the camera names, use the 

Camera Settings menu for each camera. 

To refresh the camera image and control the camera, tap or click the 

Snapshot 

button for each camera. 

For optimal performance, we recommend that you set up motion detection 
sensitivity and a motion detection schedule, as described in the Wire-Free IP Camera 
Base Station User Manual.

DRAFT

Model: VNB4000