WebGate Inc. WB101X-WG1K Benutzerhandbuch
WebEye
WebEye B101
B101 User’s Guide
9
Green LED : This LED indicates the status of networking. After power is supplied, it is on for the first 1 -2
seconds, and then it blinks once at every one second as long as the network is connected.
4) Descriptions on DIP Switches
This is to designate video signal termination. If you want to monitor real time image through a CCTV monitor
as well as WebEye, you may connect a dome camera to ‘Video Input ’ connector and a CCTV monitor to
‘Video Output’ connector. In this case, you should decide which one is terminal of video signal. WebEye is
not affected if a CCTV monitor is designated as terminal. If you connect a dome camera to ‘Video Input ’ and
monitor real time video only through a PC, place the first DIP switch (marked with No. 1) at upper position
‘ON’. If you monitor real time video through a CCTV monitor as well as a PC, connect a dome camera to
‘Video Input ’ and a monitor to ‘Video Output’. And place the first DIP switch (marked with No. 1) at lower
position ‘OFF’. If the CCTV monitor has a DIP switch and it is configurable the termination, you may change
the termination from the CCTV monitor to WebEye such as the DIP switch in WebEye ‘ON ’ and the DIP
switch in a CCTV monitor ‘OFF’. However a CCTV monitor is generally set as termination of the video
signal.
III. WebEye Installation Summary, Connection & Placing
1. Installation Summary
•
Connect Ethernet and Power to WebEye on local networ k for configuration
•
Install a setup program of WebEye to a PC on local network
•
Assign an IP address to WebEye and configure administrator’s condition
•
Configure user’s condition
•
Place WebEye for your purpose, and re -connect power and Ethernet
•
Adjust the Focus
2. Connecting
•
Connect Ethernet line to the Ethernet port in the rear.
•
Connect the power supply to a power supply port in the rear.
•
Confirm that the LED of the Ethernet port blinks
3. Placing
•
Place WebEye appropriately for your purpose
IV. Installing WebEye Setup Program
•
Copy WebEyeSetup.exe file from the enclosed CD (or Diskette).
•
Paste the file into your PC
•
Click the file on your PC to activate Setup program.