EADS-Defense & Security Networks MC9620SG2UM Benutzerhandbuch
10/242001
LANGUAGE ACCEPTABLE TO EDSN. DISTANCES BELOW ARE NOMINAL AND MAY BE
ADJUSTED IF NECESSARY FOR FCC APPROVAL.
FCC RF Exposure Compliance Requirements for Occupational Use Only:
This Radio has been tested and complies with the Federal Communications Commission (FCC) RF
exposure limits for Occupational Use/Controlled exposure environment. In addition, it complies with
the following Standards and Guidelines:
exposure limits for Occupational Use/Controlled exposure environment. In addition, it complies with
the following Standards and Guidelines:
◊
FCC 96-326, Guidelines for Evaluating the Environmental Effects of Radio Frequency
Radiation.
Radiation.
◊
FCC OET Bulletin 65 Edition 97-01 (1997) Supplement C, Evaluating Compliance with FCC
Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields.
Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields.
◊
ANSI/IEEE C95.1-1992, IEEE Standard for Safety Levels with Respect to Human Exposure
to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz.
to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz.
◊
ANSI/IEEE C95.3-1992, IEEE Recommended Practice for the Measurement of Potentially
Hazardous Electromagnetic Fields - RF and Microwave.
Hazardous Electromagnetic Fields - RF and Microwave.
1. This radio is NOT approved for use by the general population in an uncontrolled environment. This
radio is restricted to occupational use, work related operations only where the radio operator must have
the knowledge to control its RF exposure conditions.
the knowledge to control its RF exposure conditions.
2. When transmitting with the unit in front of the mouth, hold the radio in a vertical position with its microphone
away from your mouth and keep the antenna at least 1 inch (2.5 cm) away from your head and body.
3. The radio must be used with a maximum operating duty cycle not exceeding 50%, in typical Push-to-
Talk (PTT) configurations.
DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more than
50% of the time can cause FCC RF exposure compliance requirements to be exceeded. The radio is
transmitting when the red LED on the top of the radio is illuminated. You can cause the radio to
transmit by pressing the PTT button.
DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more than
50% of the time can cause FCC RF exposure compliance requirements to be exceeded. The radio is
transmitting when the red LED on the top of the radio is illuminated. You can cause the radio to
transmit by pressing the PTT button.
4. Always use EDSN Standard authorized accessories.