CipherLab Co. Ltd. 9200C Benutzerhandbuch
135
Chapter
7 Using Reader Configuration
Utility
Redundancy Level
Sets how many successful readings should be done before linear
barcodes such as Codabar, MSI, and Interleaved 2 of 5 can be
decoded. Levels 1 to 4 available.
The readings needed for each level are as follows:
The readings needed for each level are as follows:
Level 1
The following barcodes must be successfully read
twice before being decoded: Codavar, MSI, Industrial
25 (Discrete 25), Interleaved 25.
Level 2
All barcodes must be successfully read twice before
being decoded.
Level 3
All barcodes must be successfully read twice before
being decoded, except for the following which must be
read three times: MSI, Industrial 25 (Discrete 25),
Interleaved 25.
Level 4
All barcodes must be successfully read three times
before being decoded.
Scan Angle
Select the scan angle for Long Range Laser scan engine. Default is
“wide”.
“wide” for 35°
“narrow” for 47°
Scan Mode
Sets the reader’s scanning behavior. Default is “Laser”.
“Continuous” to decode the same barcode repeatedly or decode
different barcodes in a continuous motion.
“Laser” for scanning by pressing the scan trigger.
Timeout Between Symbols Only available for Continuous mode. The default value is 1 sec.
2D IMAGER SETTINGS
Barcode Reader
Description
2D Reader
The 2D scan engine is capable of reading linear and 2D barcodes.
Tap the Barcode Reader button to configure reader settings for the
Tap the Barcode Reader button to configure reader settings for the
2D scan engine.
Refer to the Reader Settings Table in Appendix IV -ʳ
2D Imager
(SE4500DL)
.
Decode Session Timeout Sets the maximum time (configurable from 1 to 9 sec) for the
decoding process during a scan attempt. The default value is 3 sec.
Decode Illumination
Decide whether to flash illumination on every barcode capture to aid
decoding.
Turn on (internal LED)
Turn off
Aiming Pattern
Decide whether to project the aiming pattern during barcode capture.
Turn on
Turn off