Xplore Technologies Corp of America UHFRFID Benutzerhandbuch
Chapter 2
Using your RFID Long Range Reader
10
Using the C5/F5-Series EasyConnect
RFID Long Range Reader
This section contains information about basic operation of the RFID Long Range Reader
when using the Motion RFID Wedge software.
To scan an RFID tag:
1. Ensure that your RFID Long Range Reader is attached to your Tablet PC.
2. Open an application that accepts text input (some examples of this are Microsoft® Word,
Microsoft® Excel, and Windows® Notepad).
3. Open the Motion RFID Wedge application (see
4. Tap the Enable Reader button and position your Tablet PC in front of the RFID tag with
the Tablet PC screen facing you as shown in the illustration below.
5. Press the button on the Tablet PC that you selected during installation of the Motion
RFID Wedge application to initiate an RFID scan.
6. The green light turns on while the RFID Long Range Reader is scanning for a tag.
7. If the scan was successful, you’ll hear a confirmation beep (unless you disabled the beep
in the Motion RFID Wedge settings) and the green light turns off. Additionally, the RFID
tag information will populate the text input application you chose. If the scan wasn’t
successful, you’ll hear a failure beep and a pop-up message is displayed indicating that
no tag was found.
tag information will populate the text input application you chose. If the scan wasn’t
successful, you’ll hear a failure beep and a pop-up message is displayed indicating that
no tag was found.
8. To scan another RFID tag, press the button on your Tablet PC.
N
OTES
:
Read range varies based on tag performance, reader antenna gain, reader output power,
and environmental conditions.
Because the RFID Long Range Reader consumes additional battery power when it’s
attached to the Tablet PC, charge your tablet overnight and when not in use.
If you remove the RFID Long Range Reader, you will need to enable it when you re-attach
it to your Tablet PC. Open Motion RFID Wedge Settings and tap
(Save
Settings)
.