Xplore Technologies Corp of America UHFRFID Benutzerhandbuch
Chapter 1
Getting Started
5
4. To remove the RFID Long Range Reader, insert your finger in the slot at the top of the
reader, pull back the tab, and slide the reader off the Tablet PC.
Semi-permanent installation
If you want to install the RFID Long Range Reader so that it stays attached to your Tablet PC
for frequent, long-term use, you can opt for semi-permanent installation.
For RFID Long Range Reader semi-permanent installation:
1. Remove the two feet that are on the back of the Tablet PC (see the illustration on the
previous page for their location).
2. Remove the screws in the recesses left after you removed the feet in Step 1.
3. Place the two plastic feet for the semi-permanent installation option (item 3 in the list of
on page 2) into the recesses left after you removed the feet in Step 1.
4. Slide the RFID Long Range Reader along the bottom of the tablets until you hear the
back of the reader click over the tab on the back of the Tablet PC.
5. Use a Phillips-head screwdriver to insert the screws provided (see item 4 in the list of
on page 2.) into the holes at the back of the reader. This attaches the
reader to the Tablet PC.
Note: To prevent damage to the reader and Tablet PC, ensure that you don’t over-tighten
the screws
6. To uninstall the reader, remove the screws you installed in Step 5.
7. Insert your finger in the slot at the top of the RFID Long Range Reader, pull back the tab,
and slide the reader off the Tablet PC.