HydroPoint data systems inc. WT008 Benutzerhandbuch
9.
Turn the Upper Line dial to the next position.
The phase options are “None,” “A,” “B,” “C,” or “D. “ When
locked on a phase other than “None,” “Beep on Message” will
turn on automatically.
locked on a phase other than “None,” “Beep on Message” will
turn on automatically.
10.
Turn the Upper Line dial to the next position.
There is a blank screen before this. Two actions can be performed
here. One action is to restart the controller microprocessor,
retaining all of the programming previously completed. This is
called a RESTART. A second action can be performed called a
RESET. This action will restart the controller microprocessor and
erase
here. One action is to restart the controller microprocessor,
retaining all of the programming previously completed. This is
called a RESTART. A second action can be performed called a
RESET. This action will restart the controller microprocessor and
erase
all of the programming previously entered into the
controller. You will be required to call HydroPoint Customer
Service and reactivate the controller. You should only do this
when directed by HydroPoint Customer Service.
Service and reactivate the controller. You should only do this
when directed by HydroPoint Customer Service.
Setting to Off
OFF stops all irrigation of your WeatherTRAK ET plus controller until
you return the Function Selector dial to “RUN” (or any other
Function position other than “OFF.”)
you return the Function Selector dial to “RUN” (or any other
Function position other than “OFF.”)
Turn the Function Selector dial to “OFF.”
The display will look like this:
The upper line of the display shows the date and time.
Jan 21 2005 12:47:56pm
Irrigation is Turned OFF
RESET/ERASE or RESTART
Hold Copy to RESET/ERASE
LOCK PHASE
None
Using Special Features
77
4.
Turn the Upper Line dial to the next position.
5.
Turn the Upper Line dial to the next position.
6.
Turn the Upper Line dial to the next position.
You enter the “Start Time” with the “Setup” function.
7.
Turn the Upper Line dial to the next position.
The default is “No.” The controller will beep when it receives
any message. If this is changed to “Yes,”at midnight it will revert
back to the default setting.
any message. If this is changed to “Yes,”at midnight it will revert
back to the default setting.
8.
Turn the Upper Line dial to the next position.
The unit is gathering statistical data on the signal integrity of
each phase. It can take several minutes to acquire sufficient data.
each phase. It can take several minutes to acquire sufficient data.
PHASE INTEGRITY
A=68 B=81 C=73 D=74
BEEP ON MESSAGE?
No
START TIMES
1st 11:00pm Hi ET 1:00pm
DATA ENCRYPTION MASK
02341234567877665244 (OK)
MICROZONE
12345678
Using Special Features
76