HydroPoint data systems inc. WT008 Benutzerhandbuch
The Display in REVIEW Shows “99+” Minutes of
Runtime
Runtime
1.
The run time programmed is greater than 99 minutes. There are
only two digits available in the display to show the run time, so
if the time actually exceeds 99 minutes it shows “99+”.
only two digits available in the display to show the run time, so
if the time actually exceeds 99 minutes it shows “99+”.
2.
This is a display issue only; the controller will irrigate the full
run time.
run time.
Troubleshooting Guide
93
The Display is Frozen
1.
Turn the Function selector to RUN.
The display should change
and show the date and time.
2.
If the display shows PHASE on the lower line:
The copy button
may be stuck in the “pressed” position. Free the copy button.
3.
If COPY button was stuck:
The controller may have been
initialized.
4.
If the controller was initialized:
You must reenter all the setup,
schedule and program information. You may need to reactivate
the controller. Call HydroPoint Data Systems Customer Service
at 800-362-8774.
the controller. Call HydroPoint Data Systems Customer Service
at 800-362-8774.
5.
If COPY button was not stuck:
The controller may need to be
initialized. Call HydroPoint Data Systems Customer Service at
800-362-8774.
800-362-8774.
ET Display Has a “P” After It
1.
Turn the Function Selector to RUN.
Check the Date and Time
settings. Be sure they are correct.
2.
Turn the Function Selector to Diagnostics.
If you see a “P” after
ET, the controller is currently running and an ET was
communicated to the unit during station operation. The
controller will label the ET as “Pending” until the irrigation
cycle(s) are complete. It will then apply the new ET to all
programs for the next irrigation.
communicated to the unit during station operation. The
controller will label the ET as “Pending” until the irrigation
cycle(s) are complete. It will then apply the new ET to all
programs for the next irrigation.
Week 1 in the Review Screen is Much Different Than
Weeks 2 Through 8
Weeks 2 Through 8
1.
When the controller is installed, any days previous to today will
not be shown in Week 1 schedule. The controller shows what
days have irrigated or it anticipates will irrigate if the weather
remains as it is today. If the controller is installed on a Friday,
there will be no irrigation days shown prior to Friday, which
may result in no irrigation days at all for week 1.
not be shown in Week 1 schedule. The controller shows what
days have irrigated or it anticipates will irrigate if the weather
remains as it is today. If the controller is installed on a Friday,
there will be no irrigation days shown prior to Friday, which
may result in no irrigation days at all for week 1.
2.
Turn the Lower Line dial to see Week 2 through 8 irrigation
days. The irrigation days will display a pattern as you look at
subsequent weeks.
days. The irrigation days will display a pattern as you look at
subsequent weeks.
Troubleshooting Guide
92