Echometer Company WS Benutzerhandbuch
Wireless Sensor User Guide
Echometer Company
5001 Ditto Lane
Wichita Falls, TX 76302
5001 Ditto Lane
Wichita Falls, TX 76302
24 Sep 2012
Scope:
This manual pertains to the products listed in Table 1 below. Associated FCC and IC
identification numbers are listed, as well as page number for the specific sensor’s installation
instructions. Table 2 includes the FCC Label design and intended installation location.
identification numbers are listed, as well as page number for the specific sensor’s installation
instructions. Table 2 includes the FCC Label design and intended installation location.
Sensor Model # : Description
FCC ID
IC ID
WPRT: Wireless Polished Rod Transducer
Q5Q-WS 10048A-WS
WHT: Wireless Horseshoe Transducer
WHT50K: Wireless Horseshoe Transducer - 50,000 pounds
WPT: Wireless Pressure Transducer
WGDA: Wireless General Data Acquisition
Table 1
All of the above utilize the same electronic PCB, Antenna, Battery, and run the same
Firmware. The PCB in each case is packaged in a fully enclosed stainless steel enclosure.
Each model includes a different transducer element wired to the PCB (such as a strain gauge,
or thermistor).
Firmware. The PCB in each case is packaged in a fully enclosed stainless steel enclosure.
Each model includes a different transducer element wired to the PCB (such as a strain gauge,
or thermistor).
The instructions and pictures below depict the WPRT model. All other models will be similar
except for differences in the physical form factor.
except for differences in the physical form factor.
Table 2
The Wireless Sensors are components of the Echometer Well Analyzer and designed to
be used with the Echometer WB100 Wireless Base, providing a wireless option for obtaining
data, (such as dynamometer, power and pressure/temperature). The data is analyzed by the
data, (such as dynamometer, power and pressure/temperature). The data is analyzed by the