Norsat International Inc. 5200-40W-STD Benutzerhandbuch
Operating the GLOBETrekker SNG
Standard™ in Manual Mode
Standard™ in Manual Mode
140
Peaking the Antenna
The peaking process involves:
1 Setting DVB Carrier
2 Sweeping the Azimuth and Elevation
3 Confirming DVB Lock
To peak the antenna, complete the following steps:
1 Choose a DVB-S carrier. To select the carrier, click on a carrier in the list shown
on Figure 55 below the Spectrum Analyzer graph.
Note: Keep monitoring the Spectrum Analyzer graph which will display the
greatest peak when the antenna has been peaked.
greatest peak when the antenna has been peaked.
2 Reset the frequency span to 10 MHz (if the frequency span is currently set at a
level higher than 10 MHz). The reading on the signal level indicator in the
Antenna Peaking box (Figure 55) should be green.
Antenna Peaking box (Figure 55) should be green.
Hint: If the signal strength indicator is red it cannot be used for peaking, reset your
frequency span until it turns green.
frequency span until it turns green.
3 Click on the Azimuth button in the Motor Control box and use the nudge
left/right arrows (refer to the previous Acquisition Process section for control
button functions) to adjust the Azimuth such that the reading on the signal level
indicator is the highest that can be achieved (value will vary depending upon the
satellite). Click Peak in the Motor Control box and wait for the button to turn
green and read “Peaked”.
button functions) to adjust the Azimuth such that the reading on the signal level
indicator is the highest that can be achieved (value will vary depending upon the
satellite). Click Peak in the Motor Control box and wait for the button to turn
green and read “Peaked”.
4 Similarly, click on Elevation button in the Motor Control box to activate this
control. Use the nudge up/down arrows to adjust Elevation such that the reading
on the signal level indicator reaches the highest number that can be achieved.
Click Peak and wait for the button to turn green and read “Peaked”.
on the signal level indicator reaches the highest number that can be achieved.
Click Peak and wait for the button to turn green and read “Peaked”.