EDU Science Co. Ltd. MS079 Benutzerhandbuch
• BATTERY INSIDE THE WIFI DIGITAL MICROSCOPE IS NOT REPLACEABLE.
FCC NOTE: FCC ID:Q6NMS079
FCC NOTE: FCC ID:Q6NMS079
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED
MODIFICATIONS OR CHANGE TO THIS EQUIPMENT. SUCH MODIFICATIONS OR CHANGE COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment.
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20cm between the radiator and
any part of your body.
• Rechargeable batteries are only to be charged by supervisory adult or children over 8 years.
• Rechargeable batteries are only to be charged by supervisory adult or children over 8 years.
Wireless IP Wifi
Digital Microscope
Model No.: MS079
0070
General Specification
Image sensor :
Main processor :
Image size :
Magnification:
Power source :
Battery life :
Charger :
USB port :
Wireless standards :
Wireless range :
Supported devices :
Software requirements :
Device Lifespan
Operating conditions :
OmniVision, 1/5 inch, 2.0 MP, CMOS sensor
240Mhz ARM926 CPU
1280*720
(USB) & 640*480(WiFi)
Basic 8x (3.5” LCD) and variable for larger LCD screens
Internal 1100mAh lithium-ion battery
2 hours
5V adapter or USB power source
USB 2.0 (USB 1.1 compatible)
IEEE 802.11n
,IEEE 802.11g,IEE 802.11b
10m indoors, 30m outdoors
Android & iOS phones, tablets, notebooks
Web browser(WiFi), Skype(USB)
2 years
Commercial grade
0 to +50˚C
20% to 95%
Hereby, Edu-Science (C.P.) Ltd. , declares that this
Wireless IP WIFI Digital Microscope is in compliance
with the essential requirements and other relevant
provisions of Directive 1999/5/EC.
This equipment should be installed and operated
This equipment should be installed and operated
with a minimum distance of 20cm between the
radiator and your body.
P38-MS079-81001000