ZTE Corporation ZXMBW-RA25 Benutzerhandbuch
ZXMBW RA25 Agile 2.5G Remote Radio Frequency Unit Installation Manual
58
Confidential and Proprietary Information of ZTE CORPORATION
Feeders Cutting
Caution:
When cutting the main feeder, label it at both ends.
Temporary labels can also be attached to the middle of the feeder. All
the labels must be consistent. Otherwise, the feeder may not be
correctly connected and the sectors may not correspond to the feeder.
Determine the length of the feeder according to the final feeder
route determined together with the user on site, and cut the
feeders according to the needed length of each feeder.
1. If the antenna feeder system is to be installed on the roof of
route determined together with the user on site, and cut the
feeders according to the needed length of each feeder.
1. If the antenna feeder system is to be installed on the roof of
a building
i. Measure the length of the main feeder for each sector
according to the feeder route;
ii. Add an appropriate margin (1m ~ 2m) to the measured
lengths when cutting the feeders.
iii. After cutting one main feeder, attach the appropriate
temporary labels onto both ends of the feeder, such as
ANT0 and ANT2. Attach the formal labels to the feeder
after it is installed;
ANT0 and ANT2. Attach the formal labels to the feeder
after it is installed;
iv. Carry the cut feeders to the roof of the building and
makes sure they are not squeezed or damaged during
the process.
the process.
2. If the antenna feeder system is to be installed on an iron
tower:
i. Hoist one end of the feeder to the top of the tower by
i. Hoist one end of the feeder to the top of the tower by
using a pulley block and pulling rope. Before hoisting,
make the upper main feeder connector;
make the upper main feeder connector;
ii. The personnel on the tower must cut the feeder
according to the distance from the point where the feeder
enters the room to the lightning arrester rack, with an
appropriate margin reserved. Make a temporary for the
lower part. Attach the formal labels to the feeder after it
is installed.
enters the room to the lightning arrester rack, with an
appropriate margin reserved. Make a temporary for the
lower part. Attach the formal labels to the feeder after it
is installed.