Linx Technologies 3F090003X Benutzerhandbuch
RK-Wi.232DTS-FCC Rapid Development Kit
User’s Manual
8 Usage Guidelines for FCC Compliance
The FCC-Wi232DTS modules included in this rapid development kit have been awarded a FCC modular
approval. That means that this module, when integrated into your end product, requires no FCC part 15
testing as long as the following guidelines are met. Failure to meet any of the following guidelines will
prevent the inheritance of the FCC modular certification.
approval. That means that this module, when integrated into your end product, requires no FCC part 15
testing as long as the following guidelines are met. Failure to meet any of the following guidelines will
prevent the inheritance of the FCC modular certification.
8.1 Antenna
Selection
In order to maintain compliance with FCC regulations, an antenna with no more than 3dBi gain must be
used. This module has been tested with the following antennas:
used. This module has been tested with the following antennas:
Radiotronix Part Number
Antenna Type
Antenna Gain
DTS Mode
LP Mode
ANT-915-04A
RP ¼ Wave Helical
2dBi
Approved
Approved
ANT-915-02A
RP ¼ Wave Whip
3dBi
Approved
Approved
ANT-915-06A
RP ½ Wave Dipole
3dBi
Approved
NOT Approved
The module, when used in DTS mode, may be used with any of the above three antennas and maintain
the requirements of the FCC grant. When operating the module in LP mode, it must be coupled to one of
the approved ¼ wave antennas; in this mode, the module may not be used in conjunction with the ½
wave dipole antenna (see above).
the requirements of the FCC grant. When operating the module in LP mode, it must be coupled to one of
the approved ¼ wave antennas; in this mode, the module may not be used in conjunction with the ½
wave dipole antenna (see above).
An approved antenna must be directly attached to the module’s reverse-polarity SMA connector in the
final application to inherit the FCC modular certification.
final application to inherit the FCC modular certification.
8.2 Module
Modification
The module must not be physically altered in any way. If any connections are made to the module that
bypass the module pins, socket, or antenna connector, the FCC modular certification cannot be inherited.
bypass the module pins, socket, or antenna connector, the FCC modular certification cannot be inherited.
8.3 End Product Labeling Requirements
Pursuant to FCC public notice DA 00-1407, the end product must be labeled on its exterior with the
following verbiage:
following verbiage:
“Contains FCC ID: Q7V-3F090003X”
8.4 Additional FCC Testing Requirements
While the module’s FCC certification can be inherited (presuming the guidelines are met), additional
testing will be required to achieve full FCC compliance for your end-product. The integrator is required to
perform unintentional radiator testing on the final product per FCC sections 15.107 and 15.109.
Additional, product-specific testing might be required. Please contact the FCC regarding regulatory
requirements for your application.
testing will be required to achieve full FCC compliance for your end-product. The integrator is required to
perform unintentional radiator testing on the final product per FCC sections 15.107 and 15.109.
Additional, product-specific testing might be required. Please contact the FCC regarding regulatory
requirements for your application.
© 2002-5 Radiotronix Inc, all rights reserved
- 13 -
11/7/2005