Mobilicom ltd. MCU-30 Benutzerhandbuch
MCU-30 User Manual
Page : 20 / 51
This page contains information which is protected by copyright and is proprietary to Mobilicom Ltd.
No part of this document
may be used, copied, disclosed or conveyed to another party without prior written consent of Mobilicom Ltd
6.1.3 RF Characteristics
Max output power: 2 x 0.5W per channel
Average output power :2x 200mW per channel (23dBm)
Noise Figure: 5dBm
Transmission Power Control Range: 50dB in 1dB steps.
Radio Access Method: OFDM - TDMA
Configuration & Diversity Support: 2X2 MIMO with MRC(RX) and CDD(TX)
Frequency Resolution: 0.25MHz
Channel bandwidth: Configurable 4.2/8.4MHz
FFT Supported: 512
Guard band: 64 sub-carries each side
Total subcarriers used per symbol: 384
Data carriers used: 336
Pilot carriers used: 48
Sub carrier spacing: 13KHz for 5MHz bandwidth with 5msec frame
Modulations: QPSK
FEC methods: CTC
FEC Ratios ¾ , ½ , ¼
Error Detection: CRC32
Full TDD asymmetrical duplexing
Flexible ratio from 1:1 to 1:9 in Mobile PTP
Resolution of 1% between all units in Mobile MESH and Collaborative MESH
networks
NOTE – The wide configurable power control range enables transmitting in low
TX power when not needed and by that reducing the power consumption.
TX power when not needed and by that reducing the power consumption.