G-Way Microwave / G-Wave PS93790C Benutzerhandbuch
5 |
P a g e
RF EXPOSURE WARNING- INDUSTRY CANADA
This system has been evaluated for RF Exposure per RSS-102 and is in compliance with the
limits specified by Health Canada Safety Code 6. The 8.5 dbi antenna must be installed so as
to provide a minimum separation distance of 87.3 cm (34.37 inches) between the antenna
and persons within the area.
L’exposition aux radiofréquences de ce système a été évaluée selon la norme RSS-102 et est
jugée conforme aux limites établies par le Code de sécurité 6 de Santé Canada. Le système
doit être installé à une distance minimale de 34.37 pouces (87.3 cm) séparant l’antenne
(8.5dbi) d’une personne présente en conformité avec les limites permises d’exposition du
grand public.
GENERAL DESCRIPTION
The downlink path of BDA receives RF signals from the base station, amplifies the signal and
transmits the signal, without changing the frequency, into a Distributed Antenna System at the
direction of the mobiles. The signal travels over a DAS medium that then dissipates the signal
to the Mobile subscribers. The uplink path receives RF signals at the Mobile side from the
DAS system, then amplifies it, and transmits the amplified signal (without changing the
frequency) to the base station.
This BDA supports Uplink and Downlink, 900 occupied distinct dedicated frequency bands.
The diplexer isolates the paths and route each signal to the proper amplifying channel.
An Automatic Level Control (ALC) allows for output power limiting. A variable step attenuator
gives 0 – 30 dB of attenuation in 2 dB steps. The use of these controls is covered in the
“OPERATION” section, later in this document.
transmits the signal, without changing the frequency, into a Distributed Antenna System at the
direction of the mobiles. The signal travels over a DAS medium that then dissipates the signal
to the Mobile subscribers. The uplink path receives RF signals at the Mobile side from the
DAS system, then amplifies it, and transmits the amplified signal (without changing the
frequency) to the base station.
This BDA supports Uplink and Downlink, 900 occupied distinct dedicated frequency bands.
The diplexer isolates the paths and route each signal to the proper amplifying channel.
An Automatic Level Control (ALC) allows for output power limiting. A variable step attenuator
gives 0 – 30 dB of attenuation in 2 dB steps. The use of these controls is covered in the
“OPERATION” section, later in this document.