SendFar Technology Co. Ltd. OAB-04004 Benutzerhandbuch
Version 1.01
6
2.3 Preparing
Installation
Before installing SF-3000 for the outdoor application in a hard-to-reach
location, we recommend to configure and test all the devices first.
location, we recommend to configure and test all the devices first.
For configuring the SF-3000, please follow the quick steps below to power
up the SF-3000.
up the SF-3000.
Step 1 Attach the 1.8m RS-232 null modem console cable to the Console
Port on the SF-3000 unit (refer to
page 4
), and the other end (DB9
female type) to a terminal or a PC running a terminal emulation
program.
program.
Step 2
P
lug the DC plug of the AC/DC power adapter into the DC Input
Port of Inline Power Injector and the wall-mount plug into a power
outlet or power strip (refer to
outlet or power strip (refer to
page 4
). The Power LED on the Inline
Power Injector will light up.
Step 3 Run the cross-over type uplink Ethernet cable from Data Input
Port (refer to
page 4
) to the Ethernet port on a PC.
Step 4
Step 5
Step 2
Step 3
Step 1:
Console Port
Connection
Version 1.01
7
NOTE: This connection is required for setting up initial configuration
information. After configuration is completed, the RS-232 null
modem console cable shall be removed, and run a cross-over
Ethernet cable from Data Input Port to PC, or a straight Ethernet
cable to LAN connection, e.g. Hub.
modem console cable shall be removed, and run a cross-over
Ethernet cable from Data Input Port to PC, or a straight Ethernet
cable to LAN connection, e.g. Hub.
Step 5
Attach
one straight Ethernet cable to the Power & Data Output
Port on the Inline Power Injector(refer to
page 5
).
Step 6
Plug the other end of the straight Ethernet cable to the Ethernet
Port (refer to
Port (refer to
page 5
) on the SF-300.
When the SF-3000 receives power over the Ethernet cable, the SF-3000
will start its boot sequence and the Active LED on the Inline Power Injector
will light up.
will start its boot sequence and the Active LED on the Inline Power Injector
will light up.
You can configure the SF-3000 via HTML browser, such as Microsoft
Internet Explorer or Netscape Navigator from a remote host or PC.
Internet Explorer or Netscape Navigator from a remote host or PC.
2.4 Basic
Configuration
2.4.1 What you need to know
The SF-3000 can be configured into two operation roles, including
Wireless Client Bridge and Wireless Client Router.
Wireless Client Bridge and Wireless Client Router.
The SF-3000 is shipped with default configuration to function as a client
bridge between an Ethernet and Wireless network by attaching SF-3000 to
the wired LAN simply. If user would configure SF-3000, please refer to the
following procedures.
bridge between an Ethernet and Wireless network by attaching SF-3000 to
the wired LAN simply. If user would configure SF-3000, please refer to the
following procedures.
2.4.2 Basic Configuration Steps
This section describes a five-step configuration procedure to setup SF-
3000 workable upon your topology requirement.
3000 workable upon your topology requirement.
Step 1 Select an operation mode for SF-3000 on the web page “/General
Config/System/”, and click FINISH to refresh this page.