Redline Communications Inc. AN100UA Benutzerhandbuch
Red
MAX
™
Base Station
User Manual
Doc. #70-00058-01-01
Proprietary Redline Communications © 2007
July 13, 2007
Page 73 of 119
a) The FTP server must be located on the network connected to an active Ethernet
port (Data or Mgmt) on the base station.
b) The FTP server must have a user account with read/write privileges.
Backup Base Station Settings
Use the following steps to backup the base station settings:
1. Start a Web browser session to the base station and login. The factory default
1. Start a Web browser session to the base station and login. The factory default
settings are as follows:
Login:
admin
Password:
admin
2. Click
Backup and Restore
in the menu and make the following settings:
User Name: Enter the username of a user that is defined on the FTP server and has
sufficient access rights to the read and write files.
Password: Enter the password for the user account.
File Name: Enter the path and name of the file to save.
When performing a backup, it is strongly recommended to use the default file
directory for the FTP server and enter only the file name in this field. It is also
recommended to specify a file name that includes the date and software revision.
Select Configuration: Select Active or Alternate.
sufficient access rights to the read and write files.
Password: Enter the password for the user account.
File Name: Enter the path and name of the file to save.
When performing a backup, it is strongly recommended to use the default file
directory for the FTP server and enter only the file name in this field. It is also
recommended to specify a file name that includes the date and software revision.
Select Configuration: Select Active or Alternate.
3. Click
Start Backup
and wait for the base station to transfer the configuration file.
This process may take a few minutes and progress is indicated in the Status field.
Restore Base Station Settings
Use the following steps to restore the base station settings:
1. Start a Web browser session to the base station and login. The factory default
1. Start a Web browser session to the base station and login. The factory default
settings are as follows:
Login:
admin
Password:
admin
2. Click
Backup and Restore
in the menu and make the following settings:
User Name: Enter the username of a user that is defined on the FTP server and has
sufficient access rights to the read and write files.
Password: Enter the password for the user account.
File Name: Enter the path and name of the file to be restored.
Select Configuration: Select Active or Alternate.
sufficient access rights to the read and write files.
Password: Enter the password for the user account.
File Name: Enter the path and name of the file to be restored.
Select Configuration: Select Active or Alternate.
3. Click
Start Restore
and wait for the base station to transfer the configuration file.
This process may take a few minutes and progress is indicated in the Status field.
4. If the restore operation was successful, and the destination was the Active memory
bank, the base station is automatically rebooted. When the base station is rebooted,
all traffic stops for about 30 seconds and then resumes as the subscribers are
registered.
all traffic stops for about 30 seconds and then resumes as the subscribers are
registered.