Redline Communications Inc. AN100UXA Benutzerhandbuch
User
AN-100U/UX Base Station
Manual
70-00058-01-04
Proprietary Redline Communications © 2010
Page 85 of 136
April 19, 2010
5
5
5
C
C
L
L
I
I
I
I
n
n
t
t
e
e
r
r
f
f
a
a
c
c
e
e
The base station can be configured and monitored using the command line interface
(CLI) commands. This section describes the procedures for configuring and operating
the base station using the CLI over a Telnet connection.
(CLI) commands. This section describes the procedures for configuring and operating
the base station using the CLI over a Telnet connection.
5.1
Connecting via Telnet
To connect to the base station, open a Telnet session to the IP address of the base
station (default address is 192.168.101.3).
station (default address is 192.168.101.3).
Figure 39: CLI - Connecting via Telnet
When the command prompt screen appears, login using the following (factory default) :
Username: admin
Password: admin
The base station may now be controlled using a set of CLI commands.
Telnet Logout
Exit from a CLI session by typing:
logout ENTER
The system will logout users automatically if no commands are received (idle) for five
minutes.
minutes.
5.2
CLI Commands
The system defaults to root mode when you login to the base station. The following table
lists all base station specific commands available in root mode. All commands are case-
sensitive.
lists all base station specific commands available in root mode. All commands are case-
sensitive.
The following table lists commands available in the root directory. These commands are
described in detail in the following sections.
described in detail in the following sections.