Airaya Corp GRID-3X3-PS Benutzerhandbuch
Airaya
- 25 -
Airaya
Proven, Fast and Affordable Outdoor Wireless Bridges
Data Encoding – Data encoding allows you to select the type of radio
transmission you would like to use. Changing Data Encoding will change
available MSC Options and available Data Streams, Radio Frequency
transmission you would like to use. Changing Data Encoding will change
available MSC Options and available Data Streams, Radio Frequency
(center channels), and Data Rate options for your bridge.
Wireless Mode – Select the desired channel size for your AIRAYA
WirelessGRID-300 bridge. WirelessGRID-300 bridges are capable of
operating on 20 or 40 MHz wide channels.
WirelessGRID-300 bridge. WirelessGRID-300 bridges are capable of
operating on 20 or 40 MHz wide channels.
NOTE
When you have finished updating the Wireless Mode, make sure to
press Update to view revised Radio Frequency, and Data Rate settings.
press Update to view revised Radio Frequency, and Data Rate settings.
Radio Frequency – Select the desired frequency of operation from the
drop-down menu. The radio frequencies that appear are dependent on
the Country Code enabled and Wireless Mode specified.
Transmission Rate – Select the desired Transmission (Signaling) Rate
from the drop-down menu. The Transmission (Signaling) Rates that
appear are dependent on the Wireless Mode specified.
Transmit Power – Select the desired Transmit Power option from the
drop-down menu. This option is dependent on the Country Code and
Radio Frequency specified.
Radio Frequency specified.
Follow these steps to update the radio network settings.
NOTE
You must press Update after each radio parameter change. Radio
parameters are interdependent, so each will change with every selection
you make.
parameters are interdependent, so each will change with every selection
you make.
1. Update the WirelessGRID-300 ID.
2. Select the MCS Mode
2. Select the MCS Mode
3. Select Wireless Mode
4. Select Radio Frequency
5. Select Data Rate
6. Select Transmit Output Power
7. Press Reboot to cycle power and enable new radio settings.
4. Select Radio Frequency
5. Select Data Rate
6. Select Transmit Output Power
7. Press Reboot to cycle power and enable new radio settings.
NOTE
All bridges in the WirelessGRID-300 network require the same MCS Mode,
WirelessGRID-300 ID, Wireless Mode, and Radio Frequency settings to
send and receive information correctly.
WirelessGRID-300 ID, Wireless Mode, and Radio Frequency settings to
send and receive information correctly.