Airaya Corp GRID-C Benutzerhandbuch

Seite von 61
 
Airaya
 – Fast and affordable outdoor wireless bridges
 
Regulatory Information 
 
FCC and Industry Canada Guidelines 
 
The radiated output power of the AIRAYA WirelessGRID Wireless Bridge is far 
below the FCC radio frequency exposure limits. Nevertheless, the device shall 
be used in such a manner that the potential for human contact during normal 
operation is minimized. It is the responsibility of the installer and users of the 
WirelessGRID to guarantee that the antenna operates at least 20 centimeters 
(8 inches) from any person. This is necessary to insure that the product 
operates in accordance with the Federal Communications Commission’s RF 
Guidelines for Human Exposure. 
 
The WirelessGRID’s built-in antennas may NOT be replaced at any time. They 
are designed to comply with the maximum EIRP limits specified by the FCC 
and Industry Canada. Modifications to the WirelessGRID, unless expressly 
approved by AIRAYA, could void the user's authority to operate the equipment. 
 
The WirelessGRID wireless bridge operates in the 5.25 to 5.85 GHz frequency 
range. High power radar systems in both Canada and the United States are 
allocated as primary users of this spectrum. These radars can cause 
interference and or damage to devices such as the WirelessGRID wireless 
bridge when used outdoors. 
 
Any host devices that contain this module is required to clearly state the 
following on the outside of the host device: “contains FCC ID: QDE-GRID-C”. 
 
The term “IC:” before the radio certification number only signifies that 
Industry Canada technical specifications were met. 
 
FCC ID: QDE-GRID-C 
IC: 4433A-GRID-C
Class A Digital Compliance 
 
NOTE: This equipment has been tested and found to comply with the limits for a Class A 
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference when the equipment is operated in a 
commercial environment. This equipment generates, uses, and can radiate radio frequency 
energy and, if not installed and used in accordance with the instruction manual, may cause 
harmful interference to radio communications. Operation of this equipment in a residential 
area is likely to cause harmful interference in which case the user will be required to correct 
the interference at his or her own expense. 
 
- 5 - 
FCC PART 15 Compliance 
 
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO 
THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL 
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, 
INCLUDING INTERFERENCE THAT  MAY CAUSE UNDESIRED OPERATION.