Airaya Corp GRID-C3 Benutzerhandbuch
Airaya
– Fast and affordable outdoor wireless bridges
Follow these steps to install and visually align outdoor antennas:
1. Attach the antenna to a mast or side of a building using the included
1. Attach the antenna to a mast or side of a building using the included
bracket.
2. Align the outdoor antenna horizontally: Loosen the horizontal
adjustment bolt and nut to visually aim the antenna at the remote
bridge. Set the appropriate horizontal angle and tighten the horizontal
bridge. Set the appropriate horizontal angle and tighten the horizontal
adjustment bolt and nut so that the angle is locked in place.
3. Align the outdoor antenna vertically: Loosen the vertical adjustment
bolt and nut on the mounting bracket and point the antenna towards
the remote end point. Set the appropriate elevation angle and tighten
the alignment bolts so that the angle is locked in place.
the remote end point. Set the appropriate elevation angle and tighten
the alignment bolts so that the angle is locked in place.
4. Secure the cable along the mast between the outdoor antenna and the
indoor bridge inside your building. Note: We recommend that you
secure the entire cable to the mast at 10-foot intervals.
secure the entire cable to the mast at 10-foot intervals.
5. Repeat steps one through four for each remote location outdoor
antenna.
6. Use the real-time Signal Strength Monitor to fine-tune received signal
strength (RSSi) between bridges. This tool is designed to maximize the
throughput of your new WirelessGRID link by providing the highest
possible signal strength across a wireless path. See the section on
“Antenna Alignment and Link Monitoring Tool” for instructions.
possible signal strength across a wireless path. See the section on
“Antenna Alignment and Link Monitoring Tool” for instructions.
TIP
If this is your first installation of an AIRAYA link, AIRAYA recommends that
you perform the bench test procedure in Appendix A before deploying the
product. This will ensure that bridges are functioning properly and fully
configured, and will allow you to become familiar with the tools for aligning
antennas and optimizing throughput before you get into the field.
you perform the bench test procedure in Appendix A before deploying the
product. This will ensure that bridges are functioning properly and fully
configured, and will allow you to become familiar with the tools for aligning
antennas and optimizing throughput before you get into the field.
- 17 -