Hansol Microsystem Co. Ltd. FD100 Benutzerhandbuch

Seite von 10
Introduction.
Than k you for purchasin g the F lash M em ory Driver from HANS OL MS
Flash Disk use a U SB port, F lash M em ory chip for new Apple iM ac, and PC
compatible own ers.
Flash Disk can be shared easily data (picture, m usic, etc) between you r personal
computer or n otebook device (with U SB port) and connect Flash Disk
FC C R F IN T E R FE R E N C E ST A T E M E N T
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and
can radiate frequency energy and if not installed used in
accordance
with
the
instruction,
may
cause
harmful
interference
to
radio
communication.
However,there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.
- Reoient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver
is connected.
- Consult the dealer or an experienced radio,TV technical for help.
- Only shielded interference cable should be used.
Finally, any changes or modification to the equipment by the user not expressly approved by the
frantee or manufacturer could void the users authority to operate such equipment,
DEVICE COMPLLES,WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING
TWO
CONDITIONS:
(1)
THIS
DEVICE
MAY
NOT
CAUSE
HARMFUL
INTERFERENCE,AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
▶ SPE CIFIC AT IO N
◈ Read and Write Flash memory
8MB,16MB,32MB,64MB,128MB
◈ This device supports plug and play without device driver file
( except Windows 98 )
◈ windows 98/ME, 2000,XP , Mc OS support
◈ UFI(USB Floppy Interface) protocol application
◈ USB high-speed transfer read/write function
( Read transfer rate : 6MB, Write transfer rate : 4MB)
◈ Draw power directly from USB port
◈ USB external cable length : 1m