Broadcom Corporation BRCM1075 Benutzerhandbuch

Seite von 9
OEM Installation Guidance Document 
For Broadcom BCM943162ZP 
FCC ID: QDS-BRCM1075; IC: 4324A-BRCM1075 
 
Page 2 of 9 
 
Any changes or modifications not expressly approved by the party responsible for 
compliance could void the user’s authority to operate the equipment. 
 
CAUTION: (this only applicable to 5GHz device) 
This device is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz 
frequency range. FCC requires this product to be used indoors for frequency range 5.15 
to 5.25 GHz to reduce the potential for harmful interference to co-channel Mobile 
Satellite systems. 
High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to 
5.85 GHz bands. These radar stations can cause interference with and/or damage this 
device. 
 
System integrators must include the FCC ID on the end product.  
 
FCC Radio-Frequency Exposure & Approval Conditions: 
1. For mobile applications: 
Antennas must be installed in the display section of Netbook/notebook/laptop computer 
to provide at least 20cm separation distance from the transmitting antenna to the body of 
user during normal operating condition.
 
For portable applications:  
-Antennas must be installed in the display section or underneath the keyboard in 
Netbook/notebook/laptop computers to provide at least 5mm separation distance 
from the transmitting antenna to the body of user , or any other person during normal 
operating condition. Configuration in tablets must be with at least 10mm antenna-to-
enclosure separation distance. 
 
-For portable applications, the WLAN antennas used must be the same antennas 
as in this filing. 
 
- For standalone SAR testing, the antenna is mounted on lossless foam material for 
testing. In order to use Broadcom modular approval, PC–OEMs must install antennas 
with non–conductive materials surrounding the antenna.  
 
2. The antenna(s) used for this transmitter must not be collocated or operating in 
conjunction with any other antenna or transmitter within a host device, except in 
accordance with FCC multi-transmitter product procedures. 
 
3. The regulatory label on the final system must include the statement: “Contains FCC 
ID: QDS-BRCM1075 and ID: 4324A-BRCM1075 “or using electronic labeling method 
as documented in KDB 784748.