Agrident Corporation ASR500 Benutzerhandbuch
05.07.2007
Page 30 of 59
ASR500 Reader Operation
Register
Cfg_
Adr
Bits to
Set
Hex value
of
Settings
Significance of the registers or their configuration
0x0E
FDX-B, HDX and H4002 activated
5
0bxx1x100x Use 125 kHz (this option is possible if only H4002
transponders activated) available at version 1.61 or
later
later
Cfg_
Time-out
Time-out
0x34
0x01*
Time in which the field is active.
After the time-out period the field activated with
Get_single_ID is switched off unless a transponder
is detected within the time interval (after this the field
is switched off immediately);
Time = register value x approx. 100 ms
(value 0x00 also yields approx. 100 ms)
After the time-out period the field activated with
Get_single_ID is switched off unless a transponder
is detected within the time interval (after this the field
is switched off immediately);
Time = register value x approx. 100 ms
(value 0x00 also yields approx. 100 ms)
* Default values specified.
** Combinations with other mentioned bit combinations for Cfg_Format are possible.
Note: Configuration of bits not described above will not be accepted and this results in the re-
sponse 'NAK'.
Following a 'Save_Cfg' command the configuration data are saved in the EEPROM where they
will be retained even in the absence of the power supply.
Important! If no 'Save_Cfg' command is given the new configuration data will be lost when the
power supply is switched off and will have to be redone after switching on again.