Robertshaw Controls Company d/b/a Invensys Home Control Systems EMSG Benutzerhandbuch
TD2002-EVX
COPYRIGHT
©
2002 INVENYS HOME CONTROL SYSTEMS
8/5/02
EMSG
Intelliway RF Gateway
General Instructions
Introduction
The Intelliway RF Gateway is a high performance
wireless broadband server that is a central part of
the Invensys GoodWatts system.
wireless broadband server that is a central part of
the Invensys GoodWatts system.
In addition to basic product description, this document
provides specifications and specific instructions for setup.
provides specifications and specific instructions for setup.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
connected.
– Consult the dealer or an experienced radio/TV
technician for help.
Caution:
This equipment is authorized for use under the
United States Federal Communication Commission Rules
and Regulations, Code of Federal Regulations Chapter 47
part 15 and must be installed in accordance with the
instructions provided in this document. Failure to install
or operate this equipment as instructed in this document
could void the user’s authority to operate the equipment.
This equipment contains no user serviceable parts. Any
modification or repairs to the internal components or to
the antenna configuration of the equipment without the
express written consent of Invensys Home Control
Systems could void the user's authority to operate the
equipment.
FIGURE 1.
Intelliway RF Gateway
Note: To comply with FCC RF exposure requirements in
section 1.1307, a minimum separation distance of 20 cm
(8 inches) is required between the antenna and all
persons.
section 1.1307, a minimum separation distance of 20 cm
(8 inches) is required between the antenna and all
persons.
Inspection
Inspect the product carton for damage. If damaged,
notify carrier immediately. Inspect the Intelliway RF
Gateway for damage. Return damaged products.
Check that the contents includes all components, as
listed below and shown in
notify carrier immediately. Inspect the Intelliway RF
Gateway for damage. Return damaged products.
Check that the contents includes all components, as
listed below and shown in
FIGURE 2. Intelliway RF
Gateway Components
:
– Intelliway server
– Power adapter
– RJ-45 ethernet cable
– Power adapter
– RJ-45 ethernet cable