Advanced Control Technologies Inc. 0685-0X Benutzerhandbuch

ZIR000 Instructions

P/D 092704

0685-01

1

Shown with supplied

wall mount bracket

The ZIR000 Wall Mounted Sensor is a component of the HomePro lighting control system.  Inclusion of this Wall
Mounted Sensor on the ZTH100 Wireless Controller menu allows remote ON/OFF control HomePro receivers to
control lighting.  Z-Wave nodes of other types can be added to the system and will also act as repeaters if they support
this function of repeating the signal received to other modules in the system.

There are no field repairable assemblies on this unit.  It is covered by a one year limited warranty.  If service is needed,
the unit must be returned where purchased.

CAUTION!  Read and understand these instructions before installing.  For indoor use only.  Retain instructions for
future use.

1.  Remove the screw from the bottom of the enclosure.

3.  Select the sensitivity setting preferred for the ZIR000 by

setting the corresponding jumpers on the electronic
module.
Note that H option is the highest sensitivity while the L
option is the lowest. See Figure 1.

The ZIR000 is designed for indoor use. It should not be mounted near large metal objects or on metal sur-
faces. It should be mounted on a wall or in a corner at a height of approximately 6.5 to 8.2 feet (2 to 2.5
meters) for the best general coverage in an average room.

The detector has been designed to avoid false alarms, nevertheless, it is best to avoid looking directly at
sources of heat such as fires and boilers, and always try to keep away from a window.

The ZIR000 can be positioned across from a radiator but not placed above one. Do not mount the ZIR000
where its field of view may be obstructed (e.g. by curtains).

39 foot (12 m) range, 110 degree coverage
with convex honeycomb hemispherical
infra-red lens

Fig. 1