Zebra Technologies Corporation IAPWR63000303 Benutzerhandbuch
Setup and Deployment
5
Assemble the IAP using the following procedure:
1. If desired, mount the IAP6300 box using the enclosed bracket. Refer to Figure 8.
2. Place the bracket at the desired position on the pole The bracket can accommodate
pole diameters between 1-3.5 inches. The bolts supplied with the bracket will
accommodate pole diameters of 2.75 – 3.5 inches. If needed, obtain a ¼-20 hex bolt of
an appropriate length for pole diameters between 1-2.75 inches (stainless steel bolts are
recommended).
accommodate pole diameters of 2.75 – 3.5 inches. If needed, obtain a ¼-20 hex bolt of
an appropriate length for pole diameters between 1-2.75 inches (stainless steel bolts are
recommended).
3. Adjust the position of the box so that the antenna will be in a vertical position. Tighten
the pivot and angle locking bolts on the shaft of the bracket as shown in Figure 9
4. Insert the antenna into the N-type Connector on the top of the box, and rotate to close.
5. Insert the IAP Power Plug into the 4-pin connector.
6. Install the weatherproof connector on the Ethernet cable as described at:
http://www.siemon.com/installation_instructions/pdf/IMAXIndustrialUTPPlug.pdf
7. Insert the Ethernet Cable into the RJ-45 port and tighten the connector to ensure a
weatherproof seal.
8. If used, insert the Media Converter Power Cable into the 3-pin connector.
9. The Test Port is unused during deployment
6 x 32 x 3/4
Angle Locking Bolt
1/4 x 1 inch Pivot Bolt
(Requres 7/16 Wrench)
Figure 9.
Bracket Adjustment Bolts
Deployment
The IAP may be mounted on a pole having a diameter of 1-3.5 inches, utilizing the provided
bracket. The antenna must have a separation distance of at least 2 meters from the body of all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter. Users and installers must be provided with antenna installation and transmitter
operating conditions to satisfy RF exposure compliance.
bracket. The antenna must have a separation distance of at least 2 meters from the body of all
persons and must not be co-located or operating in conjunction with any other antenna or
transmitter. Users and installers must be provided with antenna installation and transmitter
operating conditions to satisfy RF exposure compliance.