Secure Wireless Inc EV-290 Benutzerhandbuch

The Secure Wireless sample transmitter for AMAC has two tact switches on the printed 
circuit board (PCB) that allow flexibility in operation and programming. When in 
standard AMAC mode pressing anywhere on the top of the button will ensure that either 
or both of the PCB tact switches will be depressed. If any tact switch is pressed, the unit 
will send its transmission immediately. 
 

In programming you can choose to change the serial number OR change the operation of 
the transmitter from supervised to supervised with polling. 
 
To change the serial number: 

1)  Press and HOLD both buttons on the AMAC sample transmitter. You will need 

to press both the upper right and upper left corners of the one button to make 
sure that you are pressing both buttons simultaneously.* 

2)  Continue holding the buttons, The LED will turn OFF after it is done 

transmitting (approximately 3 seconds) and will turn back ON after 
approximately 5 additional seconds, RELEASE both buttons. 

3)  Use the left tact switch for a ‘0’ and the right for a ‘1’. Example; if the AMAC 

code that you desire is 28 then you will enter the data as follows; 

 
0 0 1 0   1 0 0 0  
_ _ _ _   _ _ _ _  

 
 

4)  You will also need to add a 0001 for a regular AMAC remote or a 1110 for a 

silent panic type key. 

 
This encoding may be different from what you have done in the past but this is the right 
format for Hex to Binary encoding. 
 

5)  Once all 12 digits have been entered the LED will flash rapidly. 

 
 
* I have supplied a two button rubber insert for programming if you feel it is easier 
during the programming sequences. 
 
To change from Supervised to Supervised with Polling: 
  

1)  Press and HOLD both buttons on the AMAC sample transmitter. You will need 

to press both the upper right and upper left corners of the one button to make 
sure that you are pressing both buttons simultaneously.*