Ruby Tech OW1000A Benutzerhandbuch

6

Installation of the OW-1000A Outdoor Wireless Access Point/Client 

Bridge requires the following: 

A Windows-based PC/AT compatible computer 炷 PC system 

requirement烉ţŦŵŵŦųġŵũŢůġőŊŊŊġĹııġŰųġŰŵũŦųġIJııĦġŤŰŮűŢŵŪţŭŦġŦŲŶŪűŮŦůŵġĭġŐŔ烉
ŸŪůťŰŸŴġ ijıııİřőġ 炸 or Ethernet data device with an available 
RJ-45 Ethernet port to run the configuration program or with 
TCP/IP connection to the Ethernet network. 

A 10/100Base-T Ethernet RJ-45 Ethernet cable is connected to 

Ethernet network. 

An AC power outlet (100~240V, 50~60Hz) supplies the power.

The OW-1000A is equipped with an Inline Power Injector module. The 

Inline Power Injector (PoE) delivers both data and power to OW-1000A 

unit via a signal Ethernet cable, and gives the following benefits to 
improve the performance vs. installation cost ratio.   

¾

  This works great in areas where you may not have power , like 
house roof.   

¾

  This also allows you to place the OW-1000A unit closer to the 
antenna, to make installation easier more thus reducing signal 

loss over antenna cabling. 

¾

  Ethernet signal travels well over CAT 5 cable but 2.4GHz signal 

doesn't do as well over antenna cabling.   

¾

  Ethernet cabling is much cheaper than Antenna cabling.