Ruby Tech OW1000A Benutzerhandbuch

9

Before installing OW-1000A for outdoor application or hard-to-reach 

location, we recommend configuring and test all the devices first. 

For configuring the OW-1000A, please follow the quick steps below to 

power up the OW-1000A.    Refer to Figure 2-2 for steps 1 through 5.   

Step1 : Connect the DC plug of the AC/DC power adapter into the DC 

Input Port of Inline Power Injector and the wall-mount plug into a 
power outlet or power strip (refer to 

). The Power LED on the 

Inline Power Injector will light up. 

Step2 : Run the cross-over type uplink Ethernet cable from Data Input 

Port (refer to

) to the Ethernet port on a PC. 

Step3 : Connect the 30m CAT 5 Ethernet cable into the OW-1000A unit.   

Hand tighten the connector. 

Step4 : Connect the remaining end of the 30m CAT 5 cable into the PoE 

labeled AP/Bridge.    This is the power side of the PoE that will power up 

the OW-1000A. 

When the OW-1000A receives power over the Ethernet cable, the 

OW-1000A will start its boot up sequence and the Active LED on the 

Inline Power Injector will light up. 

You can configure the OW-1000A via HTML browser, such as Microsoft 

Internet Explorer or Netscape Navigator from a remote host or PC.