AeroComm Corporation AC4490 Benutzerhandbuch
A P P E N D I X I I I - A P I
5 4
The remote response is dependent on the OEM’s specific needs and equipment. In many cases, remote radios are
connected to dumb devices without the intelligence to filter out or append specific portions of a packet that is
transmitted or received. Since the 7 bytes of overhead in the Transmit API command are not sent over the RF, the
remotes will receive only the payload data, “STATUS”. If auto destination is enabled on the remote radio, the
transceiver will automatically change its destination address to that of the radio it last received a packet from. When
the remote device sends its response, it will therefore automatically be routed back to the SAP.
Depending on the API configuration of the SAP, the packet will be received in one of two formats:
connected to dumb devices without the intelligence to filter out or append specific portions of a packet that is
transmitted or received. Since the 7 bytes of overhead in the Transmit API command are not sent over the RF, the
remotes will receive only the payload data, “STATUS”. If auto destination is enabled on the remote radio, the
transceiver will automatically change its destination address to that of the radio it last received a packet from. When
the remote device sends its response, it will therefore automatically be routed back to the SAP.
Depending on the API configuration of the SAP, the packet will be received in one of two formats:
R e c e i v e A P I
When Receive API is enabled, the transceiver will receive the reply data + the MAC address of the source radio.
When Receive API is enabled, every packet received by the transceiver will be sent to the Host in the following format.
When Receive API is enabled, every packet received by the transceiver will be sent to the Host in the following format.