Robert Bosch Pty Ltd VIMA01 Benutzerhandbuch
PROTOCOL SPECIFICATION
F005VP0801
ROBERT BOSCH
(AUSTRALIA) PTY. LTD.
A.B.N. 48 004 315 628
SMARTRA III IMMOBILISER
Page 43 of 49
Issue Number:
1.0
Dev No.
3881
Valid from:
14/2/06
Print Date:
23 March, 2007
© THIS DRAWING IS THE EXCLUSIVE PROPERTY OF ROBERT BOSCH (AUSTRALIA) PTY. LTD. WITHOUT THEIR CONSENT IT MAY NOT BE REPRODUCED OR GIVEN TO THIRD PARTIES.
DEV04205.9/I-1
6.1.2 Process Flow Chart: Replacing Engine Management System EMS
Insert New Engine
management System.
Replacing an Engine
Management System
Connect the Diagnostic
Tester
Enter the PIN number
according to OEM
database on the Diagnostic
Tester
return
The Diagnostic Tester will
trigger a message so EMS
will check the state of the
EMS and Smartra
correct EMS is
present
Yes
Store Diagnostic PIN
number on the EMS. EMS
changes to [learnt] state.
Send positive response to
the tester.
Go through Key teach
procedure
No
Send negative response to
the Tester
6.2 Replacing the Smartra ECU
If the Smartra is replaced in the field due to failure then the diagnostic tester will be required.
6.2.1 Equipment required to replace a Smartra unit in immo system
• Smartra [virgin] state.
• Diagnostic
• Diagnostic
Tester.
• Diagnostic PIN number from OEM secure database.