Fomotech International Corp. TWISTER2XA5000 Benutzerhandbuch

 

3 

The Twister 2X system is relatively simple to use.  However, it is very important to observe 
the proper safety procedures during ope ration.  When use properly the Twister 2X systems 
will enhance productivity and efficiency in the workplace. 

 

The following instructions should be strictly followed: 

 

1. 

Make a daily check of the transmitter casing, joysticks, and pushbuttons.  Should it 
appear that anything could inhibit the proper operation of the transmitter unit, it should 
be immediately removed from service. 

 

2. 

The transmitter voltage should be checked on a daily basis.  If the voltage is low, the 
battery pack should be recharged or replaced.   

 

3. 

The emergency stop pushbutton (EMS) should be checked at the beginning of each shift 
to ensure they are in the proper working order. 

 

4. 

In the event of an emergency, activate the emergency stop pushbutton immediately.  
Then turned the power “off” from the main power source of the equipment.   

5. 

The power switch should be turned “off” after use and should never left the power “on” 
when the unit is unattended.   

 

6. 

Do not use the same RF channel and ID code as any other unit in use at the sa me 
facility (within 300-meter range / 900 feet). 

 

7. 

Ensure the waist belt is worn at all time during operation to avoid accidental dropping. 

 

8. 

Never operate a crane or equipment with two (2) transmitter units at the same time with 
same RF channel and ID code.