3M Traffic Safety Systems 6204 Benutzerhandbuch
1 2 3 4 5 6 7
8
8
8
8
9
Configuring Digital I/Os
Configuring Digital I/Os
Configuring Digital I/Os
Configuring Digital I/Os
82
82
82
82
3M Toll RFID Reader 6204
3M Toll RFID Reader 6204
3M Toll RFID Reader 6204
3M Toll RFID Reader 6204 User’s Guide
User’s Guide
User’s Guide
User’s Guide
Any time the
RUN_SCRIPT
operation is invoked, the reader will sequence
through a maximum of 10 modem commands as follows:
modem.dio.in.X.script.num_cmds = Q
modem.dio.in.X.script.cmd1 = Z
modem.dio.in.X.script.cmd2 = Z
modem.dio.in.X.script.cmd3 = Z
.
.
.
modem.dio.in.X.script.cmd10 = Z
where:
Q
is the number of commands.
Q
can be
0
to
10
(maximum 10
modem commands).
Z
can be any modem command
An event
event.response.modem_dio_scripts dio_in=*,
cmdnum=*, resp=***
is generated after each modem command.
Digital outputs 3 and 4 can be driven by modem after setting the following:
dio.control.X = modem
Actions that triggered the output can be defined by:
modem.dio.out.X.op = Y
where
Y
can be:
NOOP
(default)
END_OF_ROUND
(generates a pulse at end of each inventory round)
ACTIVE_MODE
(triggers high in active mode)
SCRIPT_RUNNING
(triggers high when digital input io triggered
script is running)
ANTENNA_FAILURE
(triggers high in antenna failure state)
ERROR
(generates a pulse when an error occurs)
WARNING
(generates a pulse when an warning occurs)
All output (level/pulse) polarity is defined by:
modem.dio.out.X.polarity = Z
where
Z
can be:
POSITIVE
(default)
NEGATIVE
All pulse width (in µSec) is defined by:
modem.dio.out.X.pulse_width
–(default 100 µSec)