Angelcare Monitors Inc. AC423T Benutzerhandbuch
1) Press the Channel button
to enter the channel mode.
2) Press and hold the Nusery Unit back
button until the Night Light flashes.
3) Press and release the Nusery Unit back
button to change the channel your
monitor transmits on (C1 to C8).
monitor transmits on (C1 to C8).
4) Press and hold the Nusery Unit back
button until the Night Light stops
flashing to confirm your channel
selection and quit to normal mode.
flashing to confirm your channel
selection and quit to normal mode.
NOTE
:
If the transmission is not clear, or if you hear
interference sounds, you should change
the
channel.
STEP 3 - TURN ON YOUR MONITOR
1) Press the Parent Unit ON/OFF button
for 2 seconds.
2) Slide ON the Nursery Unit Power
ON/OFF button.
NOTE:
The screen of the Parent Unit will show
the channel of transmission (C1 to C8).
Then temperature reading will replace
the channel display.
the channel of transmission (C1 to C8).
Then temperature reading will replace
the channel display.
If there is no temperature display, turn OFF and
then ON the Nusery Unit again. The channel
display will then turn to temperature reading
in one minute.
then ON the Nusery Unit again. The channel
display will then turn to temperature reading
in one minute.
CHANNEL SELECTION
1
2
1
2
3
4
TO SELECT THE CHANNEL:
If there is a lost connection
between the 2 units
(refer to troubleshooting p.16):
between the 2 units
(refer to troubleshooting p.16):
• The Out-of-range icon
(if activated) will blink
on the screen and the Parent
Unit will beep.
(if activated) will blink
on the screen and the Parent
Unit will beep.
The Antenna icon
will blink.
will blink.
The Antenna icon
will blink with present
of the channel
number display
will blink with present
of the channel
number display
10