Cleveland Medical Devices Inc. 0007 Benutzerhandbuch

Cleveland Medical Devices Inc. 

                                                             BioRadio 110 User Guide

 

                                                                                                                                                  13 

Before capturing data with BioRadio Capture, you must configure the BioRadio unit. 
 
Access the Capture Options dialog by: 

 

  8 

Selecting Options… from the File menu  

 
Setting the Transmitter Configuration: 
Specify the configuration of the BioRadio 
Transmitter using the drop-down menu.  A 
custom configuration can be created using 
the BioRadio Configuration Wizard.  For 
your convenience, several template 
configurations are available for selection.  
In order to use any configuration the 
BioRadio (Transmitter and Receiver) 
must be programmed to the selected 
configuration, see Configuring the 
BioRadio.  
 
Setting the Receiver Port: Make sure that 
the Receiver Port is set to the proper COM 
port (the port to which your BioRadio 
Receiver is attached).  If you are uncertain 
about the COM port setting, refer to the 
documentation that came with your computer.  Choose the correct Receiver Port using 
the drop-down menu (COM 1, 2, 3 or 4) and click OK when finished. 

Setting the Frequency:  Depending on the specific BioRadio unit you purchased, you 
may have to set the RF frequency for the Receiver to match the Transmitter.  Refer to the 
documentation which was packaged with your BioRadio unit to determine the proper 
setting for the RF frequency.  You can click on the up/down arrows to set the frequency 
number (and the corresponding RF frequency, in MHz, is displayed).  
 
Click OK to save the settings to be used the next time you run BioRadio Capture. 

392-0000rev1.pub 
page 13

Thursday, November 12, 1998 15:39