Data Critical Corporation AVTS1010 Benutzerhandbuch
AlarmView™ System User’s Guide
{insert part #} Page 32
5. Tap CHECK to retrieve current system configuration
parameters.
6. a. To change sending frequency, tap Down Arrow in the
MHz field. Sending frequency is frequency transmitted from
transmitter to pager.
b. To change baud rate, tap Down Arrow in the bps field.
This programs transmitter baud rate to match pager
receiving baud rate.
c. To change Global Cap Code, tap All Pagers and use
keyboard to type in new Global Cap Code.
transmitter to pager.
b. To change baud rate, tap Down Arrow in the bps field.
This programs transmitter baud rate to match pager
receiving baud rate.
c. To change Global Cap Code, tap All Pagers and use
keyboard to type in new Global Cap Code.
7. Aim programmer infrared port directly at infrared port on
front of transmitter and tap SEND to program configuration
changes into transmitter.
changes into transmitter.
8. Repeat programming for every transmitter in system.
9. Tap Exit to return to SysMgr.
Changing Reminder Page Interval
If initial page is not acknowledged at assigned pager(s) or at the
monitor, a Reminder Page is sent to all pagers in the system. To
change the delay interval for reminder page:
1. From SysMgr, tap Start button and tap Install Program.
2. Enter password. Alarm screen will be displayed.
{Insert alarms screen with reminder interval highlighted (Figure 6-7)}
Alarms Screen Reminder Page Interval
3. To send a reminder page after a certain interval, tap Down
Arrow in the Sec. field.