ADC Telecommunications Inc. F0694-011 Benutzerhandbuch

6-30

CONFIDENTIAL

• Never combine multiple sectors (more than one CDMA signal at the same fre-

quency) into a Fusion Wideband system. The combined CDMA signals will inter-
fere with each other.

• Try to minimize overlap between in-building coverage areas that utilize different 

sectors, as well as in-building coverage and outdoor coverage areas. This is impor-
tant because any area in which more than one dominant pilot signal (at the same 
frequency) is measured by the mobile will result in soft-handoff. Soft-handoff 
decreases the overall network capacity by allocating multiple channel resources to 
a single mobile phone.

Process Gain

The process of de-spreading the desired signal boosts that signal relative to the noise and interference. 
This gain needs to be included in the link budget. In the following formulas, P

G

 = process gain:

 = 10log

10

(1.25 MHz / 9.6 Kbps) = 21 dB rate set 1

 = 10log

10

(1.25 MHz / 14.4 Kbps) = 19 dB rate set 2

Note that the process gain can also be expressed as 10log

10

 (CDMA bandwidth) minus the information 

rate.

Eb/No

This is the energy-per-bit divided by the received noise and interference. It’s the CDMA equivalent of sig-
nal-to-noise ratio (SNR). This figure depends on the mobile’s receiver and the multipath environment. For 
example, the multipath delays inside a building are usually too small for a rake receiver in the mobile (or 
base station) to resolve and coherently combine multipath components. However, if artificial delay can be 
introduced by, for instance, using different lengths of cable, then the required E

 is lower and the mul-

tipath fade margin in the link budget can be reduced in some cases.

If the receiver noise figure is NF (dB), then the receive sensitivity (dBm) is given by:

 

= 

NF + E

 + thermal noise in a 1.25 MHz band – P

= NF + 

 – 113 (dBm/1.25 MHz) – P

Noise Rise

On the uplink, the noise floor is determined not only by the Fusion Wideband system, but also by the num-
ber of mobiles that are transmitting. This is because when the base station attempts to de-spread a particu-
lar mobile’s signal, all other mobile signals appear to be noise. Because the noise floor rises as more 
mobiles try to communicate with a base station, the more mobiles there are, the more power they have to 
transmit. Hence, the noise floor rises rapidly:

noise rise = 10log

(1 / (1 – loading))

where loading is the number of users as a percentage of the theoretical maximum number of users.

Typically, a base station is set to limit the loading to 75%. This noise ratio must be included in the link 
budget as a worst-case condition for uplink sensitivity. If there are less users than 75% of the maximum, 
then the uplink coverage will be better than predicted.

Hand-off Gain

CDMA supports soft hand-off, a process by which the mobile communicates simultaneously with more 
than one base station or more than one sector of a base station. Soft hand-off provides improved receive 
sensitivity because there are two or more receivers or transmitters involved. A line for hand-off gain is 
included in the CDMA link budgets worksheet although the gain is set to 0 dB because the in-building 
system will probably be designed to limit soft-handoff.