Lelux Electronics Ltd 615 Benutzerhandbuch

• Including PIR Sensor & Receiver
• Wireless RF Transmission Up to 400 Feet
• PIR Sensor Detect Motion and Trigger Receiver Turn on Chime
• Sound Hi/Low Switch
• Chime On/Off Select Switch
• PIR Sensor 9V Battery (not included) Operation
• Receiver 3 C Size Batteries (not included)         
• Compatible with DC Adaptor (not included) for Receiver Unit
• Battery Low Indicator LED for PIR Sensor and Receiver
• Trigger Flash LED
• No Wiring, Easy to Installs 
• Water Resistant for PIR Sensor

1. Remove the screw of Pir sensor unit and Receiver unit  from battery compartment cover, screw 

it off to remover the cover.(Fig.1)

2.  Install an alkaline  9V batteries (not included) for pir sensor, 3x1.5 "C-size" batteries for 

receiver to the battery compartment make sure install with correct  polarity. (Fig. 2)

3. Hang the pir sensor at the entrance of your driveway (such as on a mailbox, on a tree or on a 

ground stake). You may also place the pir sensor on your garage, near the front entrance or 
rear door. Any movement nearby will transmit a signal to the receiver chime unit triggering it to 
signal the chime.(Fig.3)

Wireless Driveway Alert System

Model 615 

size:145x205mm
p/n:610-6150x-00x

4. Please ensure to place the pir sensor unit at least three feet high above the ground.

5. On/Off switch of receiver

Turn the switch to ON position, now the unit is standby to working mode, when pir sensor 
detected trigger, will sound door chime and the led will light up. You can turn HI/LOW switch to 
select sound volume.

6. To test the pir sensor unit detection area

After selecting  a location for installation of the unit you can turn the switch to on and wait for 30 
seconds for "WARM-UP". Then you  try walking in front of the unit. When the unit detects motion, 
the chime will sound. There will be no chime sound if you walk beyond the detection range. By 
testing the detection range, you can adjust the location the sensor angle for best coverage. Turn 
the chime off after your test.

7. Battery low indicator
  A) Pir sensor

When pir sensor batteries goes low, the LED will lighting to indicate the low battery. Then replace 
the new battery.
B) Receiver
When receiver batteries goes low, the LED of the middle will lighting to indicate the low battery. 
Then replace the new battery.

8.  Power  adapter  (not  included)  for  receiver  unit  with  output  6V  DC,  200mA  female  plug,  center      

( + ) positive can be applied to the DC jack for long time use.

(Fig. 2)

(Fig. 1)

Fig.3

This  device  complies  with  Part  15  of  the  FCC  Rules.  Operation  is  subject  to  the  following  two 
conditions: (1) this device may not cause harmful interference, and (2) this device must accept 
any interference received, including interference that may cause undesired operation. Changes 
of modifications not expressly approved by the party responsible for compliance could void the 
user’s authority to operate the equipment.